What would you do if you want to upgrade your driving experience? Some car owners may choose to by a new car for newperformance, which is impractical for a plenty of car owners. In fact, you can easily replace your old factory radio with a brand new car radio with a lot of upgraded functions and new features which can take your driving experience up a notch. Here us an installation guide from Seicane specially for a 2005-2011 DODGE RAM Pickup Trucks Avenger /Caliber/Challenger/Dakota 3G WIFI radio. Wish you can get some help from it.
Before and during installation, you should notice:
1.Before connecting, please make sure the ignition is off to avoid short circuit.
2.Ensure connect the yellow and red power cable at last.
3.Ensure that all loose wires are isolated with electrical tape
4.Ensure don’t tangle the wire when tighten the moving parts(Such as seat rails).
5.Ensure that all ground is connected to the same place.
6.Using the improper fuse may cause damage of fire, so when replace the fuse, please consult the professional.
7. For your convenience, here’s the recommended tools for removal and installation from Seicane, please check for more details: http://www.seicane.com/car-dvd-dismantling-devicesrd-400
2005-2011 DODGE RAM Pickup Trucks Avenger /Caliber/ Challenger/ Dakota car radio Installation Steps
1. The original car radio.
2. Grab at the bottoming plastic cover, push the bottoming box and release it.
3. Remove the original panel with a plastic knife, pry gently along the gap and pick up the panel, then remove it and then set it aside.
4. Unplug the connectors at the back of panel.
5.Remove four screws that fixed the radio on the dashboard.
6. Gently pull the factory radio out of the dash. Then unplug the connectors at the back of the factory radio.
7. Check all the accessories for the new Seicane head unit.
8. Connect the harnesses to the back of the new Seicane head unit.
9. Connect the Seicane head unit to your original head unit ‘s plugs.
10. Turn on the new Seicane head unit to have a careful check if everything works well. If it doesn’t, please check whether all the cables are connected correctly.
11. Put the new Seicane head unit into the dash.
12. Put everything into their original place. All the installation is done.
Wish the above instructions can be helpful for you if you are going o upgrade a car radio for your beloved car. If there is any question, you can turn to your dealer for help. If you don’t have related experience, you can directly go to a car stereo upgrade center to have your car radio installed by a technician. To select a compatible car radio, you can search online and check the link below which is about a 2005-2011 DODGE RAM Pickup Trucks Avenger /Caliber/Challenger/Dakota 3G WIFI radio and take it as a reference.
This intelligent car radio is compatible with a 2005-2011 DODGE RAM Pickup Trucks Avenger /Caliber/Challenger/Dakota 3G WIFI radio, will offer you the best services through its practical functions and additional entertaining features. The 3D GPS navigation system of high accuracy provides lane assist, 3D street view, landmark display, route planning, voice prompts and turn-by-turn direction for you to find your way to a variety of locations. Moreover, you can utilize its built-in Bluetooth to wirelessly pair your enabled mobile phone to accept and receive hands-free calls and stream audio to keep safe and enjoyable. Wish you like it and good luck to you!