Recently, a lot of car owners have successfully upgraded their factory radio with an aftermarket car radio, which can bring much convenience as well as enjoyment to them on the way. If you are going to replace your factory radio, then you can read this passage carefully to help with the installation, which is a step-by-step 2005-2010 Skoda FABIA car radio installation guide from Seicane.
2005-2010 Skoda FABIA car radio after installation
Safety notes
1. Before connecting, please make sure the ignition is off to avoid short circuit.
2. Ensure connect the yellow and red power cable at last.
3. Ensure that all loose wires are isolated with electrical tape
4. Ensure don’t tangle the wire when tighten the moving parts(Such as seat rails).
5. Ensure that all ground is connected to the same place.
6. Using the improper fuse may cause damage of fire, so when replace the fuse, please consult the professional.
2005-2010 Skoda FABIA car radio installation guide
1. Remove the top panel with a lever.
Remove the top panel with a lever
2. Disconnect the connector at the back of the panel.
Disconnect the connector at the back of the panel
3. Unscrew the screw with a screwdriver.
Unscrew the screw with a screwdriver
4. Remove the metal sheet on the top with your hands.
Remove the metal sheet on the top with your hands
5. Unscrew two screws circled in red shown as follows under the metal sheet.
Unscrew two screws circled in red shown as follows under the metal sheet
6. Remove the air conditioner vent with your hands.
Remove the air conditioner vent with your hands
7. Unscrew two screws under the vent with a screwdriver.
Unscrew two screws under the vent with a screwdriver
8. Remove the panel on the original car radio.
Remove the panel on the original car radio
9. Unscrew four screws holding the original car radio with a screwdriver.
Unscrew four screws holding the original car radio with a screwdriver
10. Take the original car radio out of the dash.
Take the original car radio out of the dash
11. Disconnect all the connectors at the back of the original car radio.
Disconnect all the connectors at the back of the original car radio
12. Check all the accessories for the new Seicane car radio.
13. Connect the harnesses to the back of the new Seicane car radio.
14. Connect the Seicane car radio to your original car radio ‘s plugs.
15. Turn on the new Seicane car radio to have a careful check if everything works well. If it doesn’t, please check whether all the cables are connected correctly.
16.Put the new Seicane car radio into the dash.
17. Put everything into their original place.
Above all, you need to make clear about every step before you start to install this 2005-2010 Skoda FABIA car radio in your car. If there is any question, you can seek help from your dealer. If you don’t have any experience on the installation, it’s strongly suggested you ask a professional to install your new unit. If you are still looking for a suitable head unit for your car, I’d like to recommend a modern 2005-2010 Skoda FABIA car radio from Seicane to you. Please click for more details:
This intelligent Skoda FABIA car radio is an amazing replacement for you to upgrade your factory radio. It is built with an advanced Android 5.1.1 system to smooth the operation. A large 8 inch 1024*600 multi-touch screen is ideal for you operate and view everything. To have a different driving experience, this car radio is just the best choice for you!