Before we talk about installation guide for 2010-2014 Chevrolet Orlando radio tv bluetooth Ipod,I think we should have a general idea about this new radio which has more advanced functions.Here is an image for it,head unit after installation,radio gps bluetooth mp3 of 2010-2014 Chevrolet Orlando:
We can see that this car dvd dashboard is a little different from other ones for this stereo has two operations:one is touch screen which can be used with a touch screen pen,the other is push button system,you can operate this unit by both ways.But it doesn’t matter removing your original stereo only if your radio dashboard is alike with above one.
Thus the next question comes to how will us install gps radio for 2010-2014 Chevrolet Orlando,actually it is a normal work that can be fulfilled by ourselves,but on the condition that we have known correct installation guide and act according to it.And here gives you specific procedure of this action.
1.Use a panel removal tool,gently pry the upper vent housing panel from the dash
2.Pry the shifter surround panel,on manual transmission vehicles,unclip and reposition the shifter
3.Remove 2 screws from the storage pocket,remove storage
4.Remove 4 screws from the accessorv control panel
5.Pull out on panel,this panel was very tough to remove,be patient and the clips will release let panel hang to side
6.Remove 2 screws from the radio control panel, disconnect the radio control panel
7.This is a really strange blue clip you must remove the blue clip completely before removing the real connector,and remove the other clip
8.Remove 2 screws from the radio chassis,and 2 screws near the top of the stereo to release the screen
9.Remove screen by pulling out,remove behind clip
10.Remove 2 more screws on stereo
11.Remove stereo and connectors
Removal process is over here,the nex job is to install a new Chevrolet Orlando radio which may be easier than above actions. What you need to do is to plug connectors of new unit to original one’s precisely,you can do read installation instructions carefully and you will find answers from it.After connecting all connectors,tidy them in order to avoid damage for cables and antennas,then install your new stereo into the car.
When you have done these things,you can turn on your radio and check whether it can work well.If it’s ok,then you can firm those screws which were removed before and mount storage,shifter and upper vent housing panel back to right places.Thus the whole procedure is achieved and you will enjoy a good journey in your car.
If you have some doubts on this dvd player,you may have a look at this video for help:
Attention:please keep everything that are removed well especially the screws for they are small but useful,for once use again.It can be very distraughted if you can’t find a necessary thing.