Car stereo audio after installation,GPS radio audio with navigation system of 2012 2013 Chevrolet Colorado.
I guessyou may be curious about this new stereo for it’s a little different from your factory one on its outward and features.New unit’s screen is a touch screen which can be operated by a special touch screen pen.And it has increased some convenient and entertaining functions,if you want to know it more detail,you can visit some related websites,for example:http://www.seicane.com/oem-aftermarket-car-audio-bluetooth-dvd-player-for-chevrolet-colorado-with-3g-wifi-gps-e-book-a2dp-support-radio-upgrade-can-bus-c203 . It should be more convenient if your Chevrolet Colorado has upgraded car audio.
So many drivers would like to install one but have no idea about how to install 2012 2013 Chevrolet Colorado navigation system with BT touch screen.Don’t worry,it’s not hard to behave and also doesn’t need much professional skills,it just need you to be patient to know its operation and careful to do it.
I will show you detailed installation steps for Chevrolet Colorado navigation system in the following part,please be patient to read it and hope you will benefit a lot. 2012 2013 Chevrolet Colorado radio removal and nav system installation: 1.Gently pry the upper vent housing panel from the dash with a panel removal tool
2.Lever the shifter surround panel,on manual transmission vehicles,unclip and reposition the shifter
3.Make out 2 screws from the storage pocket,remove storage
4.Make out 4 screws from the accessorv control panel
5.Pull out on panel,this panel was very tough to remove,be patient and the clips will release let panel hang to side
6.Make out 2 screws from the radio control panel, disconnect the radio control panel
7.This is a really strange blue clip you must make out the blue clip completely before removing the real connector,and remove the other clip
8.Make out 2 screws from the radio chassis,and 2 screws near the top of the stereo to release the screen
9.Make out screen by pulling out,remove behind clip
10.Make out 2 more screws on stereo
11.Make out the unit and connectors
You see,removal affairs has been finished,the following thing is to install a new stereo for your beloved car,and this following part is actually easier than removing steps.
When you have carefully read over installation instructions,make corresponding cables connection which you should try to make sure it precise.Please pay more attention on this because it’s very important to your installation.
After that sort some disordered antennas and install new unit gently into the right space. Turn on new unit and have a careful check for your installed head unit to see whether it can work properly.If the answer is yes,then continue actions including screwing screws tight to original places and reinstalling storage and trim panel to make everything back.
You will enjoy very good time after you have finished whole procedure and drive a car with such a multimedia dash dvd with GPS bluetooth touch screen.