With an attractive convenient and humanizing user interface, the OEM aftermarket car stereos are more and more popular with car owners. They can not only improve the interior environment but also upgrade the capabilities of the car radio which can bring a new experience. If you are a car owner of a 2003-2011 Porsche Cayenne, please look at the picture below. If you also have the same dashboard, you can take this detailed 2003-2011 Porsche Cayenne car stereo installation guide from Seicane as a reference to help with the installation of your new car stereo.
Before and during installation, you should notice:
1.Before connecting, please make sure the ignition is off to avoid short circuit.
2.Ensure connect the yellow and red power cable at last.
3.Ensure that all loose wires are isolated with electrical tape
4.Ensure don’t tangle the wire when tighten the moving parts(Such as seat rails).
5.Ensure that all ground is connected to the same place.
6.Using the improper fuse may cause damage of fire, so when replace the fuse, please consult the professional.
7. For your convenience, here’s the recommended tools for removal and installation from Seicane, please check for more details: http://www.seicane.com/car-dvd-dismantling-device-srd-400
2003-2011 Porsche Cayenne car stereo installation guide
1.Pry out the trim piece along the perimeter of the center dashboard with a lever.
2.Remove 2 screws holding the stereo in the dashboard frame (green arrows). Please note that there will be four screws in the cars with navigation.
3.Carefully take the factory stereo out of the dash. When removing the factory radio, please note that there are two locking tabs on the lower tray that can break easily.
4.Here is a close-up of the underside of the stereo. These two plastic fingers (green arrows) fit into the tabs on the top edge of the lower tray.
5.Press the tab (green arrow) on the antenna lead and pull it out of the stereo.
6.Pull out the connectors at the back of the stereo (green arrows). Note that some cars may have different setups based on the vehicle’s different years.
7. Check all the accessories for the new Seicane car stereo.
8. Connect the harnesses to the back of the new Seicane car stereo.
9. Connect the Seicane car stereo to your original car radio ‘s plugs. And put the new Seicane car stereo back into the dash.
10.Install two screws and trim piece.
11.Turn on the new radio and have a comprehensive test.
Wish you can get some help from the above installation guide for a 2003-2011 Porsche Cayenne car stereo. You may have any question during the whole process, you can turn to your dealer or a professional for help. If you don’t have enough experience to install a new car stereo, it’s strongly suggested you have it installed by a professional.
By the way, are you still looking for a suitable car stereo for your car? If you say yes, then I’d like to recommend this amazing 2003-2011 Porsche Cayenne car stereo from Seicane to you. Here’s the link, please click for more details:
This modern Porsche Cayenne car stereo with a large 7 inch touch screen can be well combined with 2013 Toyota RAV4 at present. You can play DVD, CD, VCD, FM/AM radio, Ipod, TV, etc. to entertain both you and your passengers. With the intelligent route planning, turn-by-turn direction and voice prompts, you can travel anywhere you’d like without getting lost any more. If you want to keep safer and more cheerful on your way, you can easily pair with your enabled mobile phone to make and receive hands-free calls and stream music.
To have a relaxing time on all your trips, this intelligent Porsche Cayenne car stereo is just your best companion. Have a good time!